PDA

View Full Version : Glovebox lock removal help.



Coolza
08-11-2010, 03:36 AM
Anyone have a clue how to remove the lock cylinder out of the glove box?
I have new plastics for it and want to retain my original metal, but i can for the life of me figure out how the damned lock assembly comes out.. lol

70-K5
08-11-2010, 04:51 AM
It screws on.

elecdust
08-12-2010, 04:43 AM
I broke 2 of these trying to get them out. On the inside of the box, on the top of the cylinder, just to the right of the latch and closer to the plastic there is a square hole about 2.5mm x 2.5mm. At this point I forget alittle. Not sure if I closed the latch and then moved a little bar to the side and then was able to wiggle and pull the lock cyclinder out. But you do release the lock cyclinder from that small square hole. Try messing with it a few different ways. Once you get that out you just unscrew a small close nipple and its all off.

NightKrwlr
08-12-2010, 01:47 PM
dynamite

89 CUSTOM RUST
08-12-2010, 03:12 PM
BFH

89 CUSTOM RUST
08-12-2010, 03:25 PM
BFH

elecdust
08-12-2010, 08:34 PM
I'm lost. What does BFH mean?

Jacks89K5
08-12-2010, 08:48 PM
BIG FUCKING HELP (I think)

spectreblazer
08-12-2010, 09:37 PM
Big Fucking hammer

Coolza
08-18-2010, 02:47 AM
I got em out thanks for the help.
ya it basicly just unscrewed after you popped out the cylinder.

70-K5
08-18-2010, 03:48 AM
It screws on.
Yea, I said that... :sarcasm2: